Tronic H12276 - Manual (Page 23)

23 GB/MT
Q
Before use
Q
Insert / change battery
j Remove the cover of the battery compartment 3 by pulling it off in the direction of the arrow
(see illustration).
j Insert a micro battery (AAA 1.5 V).
Note: Please observe the correct polarity. This is indicated in the battery compartment.
j Then close the battery compartment again.
Q
Operating instructions
Q
Measuring D, C, AA and AAA battery
j Place a battery of the type D, C, AA or AAA in the battery tester (see fig. A).
Note: In doing so, please observe the correct polarity. This is shown on the battery tester.
Note: Please ensure for proper contact between the battery and the battery tester.
j Secure the battery by means of the extendable contact arm 1 (see fig. A).
j Read the voltage of the connected battery using the voltage display 5 and the 1.5 V scale 4 .
Q
Measuring 9 V battery
j Position the 9 V battery on the test contacts 7 (see fig. B).
Note: In doing so, please observe the correct polarity. This is shown on the test contacts 7 .
Note: Please ensure for proper contact between the battery and the test contacts 7 .
j Read the voltage of the connected battery using the voltage display 5 and the 9 V scale 6 .
Q
Troubleshooting
= Fault
= Cause
= Solution
Battery tester does not react.
Electrostatic discharge can affect the function of the battery tester.
Press the reset button 2 on the back of the battery tester. For this purpose a paper clip or a
similar object can be used.
The battery to be tested has been inserted incorrectly.
Insert the battery to be tested according to the correct polarity.
86629_ES-IT_Content.indd 23 20/09/2012 11:42:21