Cleaning, Timer control, Charging a usb device – Tronic TLG 1000 C5 User Manual
Page 35: Cleaning the housing
32
TLG 1000 C5
GB
Timer control
In addition, this battery charger has a timer control which automatically switches
over to retention charging after 17 hours. This serves as an additional protection
against overcharging should the charge termination not respond due to a possibly
defective battery.
Charging a USB device
IMPORTANT
►
Ensure that the power consumption of the USB device is not higher than
1000 mA. For more information, refer to the instruction manual of your
USB device.
♦
Insert the USB connector of the USB device into the USB output
5
of the
battery charger.
♦
If necessary, switch the USB device on.
NOTICE
►
You can simultaneously charge batteries in the battery charger and a USB
device at the USB output
5
. Be aware that the charging current for the batter-
ies is thereby halved and the charging process thus takes somewhat longer.
Cleaning
DANGER
►
Always remove the plug before cleaning the device. There is the risk of an
electric shock!.
►
When you are cleaning the device ensure that no moisture gets inside it, so
as to avoid irreparable damage to it.
IMPORTANT
►
Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.
Cleaning the housing
♦
Clean the surfaces of the device with a soft, dry cloth. For stubborn soiling
use a lightly moistened cloth.
♦
Never clean the insides of the charging slots with moist cloths. Instead, use
a clean soft brush to clean them.
♦
If soiled, clean the charging contacts with a dry cloth.
IB_100039_TLG1000C5_LB2.indb 32
IB_100039_TLG1000C5_LB2.indb 32
25.06.14 11:22
25.06.14 11:22