Extron electronic MIX 301 - Manual (Page 4)

MIX 301 • Installation and Operation MIX 301 • Installation and Operation
Installation and Operation, cont’d
3
Installation and Operation
2
1. Attach the rubber feet to the underside of the MIX 301 near
the corners of the unit.
2. Place the MIX 301 unit in the desired location.
Rack installation
The MIX 301 can be rack mounted using either the VersaTools 19"
1U rack shelf (Extron part #60-190-20), basic VersaTools rack shelf
(Extron part #60-604-20), a standard universal 1U rack shelf
(Extron part #60-190-01), or a 1U basic rack shelf (Extron part
#60-604-01). Figure 1 shows the VersaTools rack shelf, and figure
2 shows a standard rack shelf. On the standard rack shelf, there
are eight mounting locations at the front of the shelf or eight at
the rear of the shelf.
1. Remove the rubber feet from the unit, if previously
installed.
2. Mount the unit on the rack shelf, using two 4-40 x 3/16"
screws. These screws go into holes on the underside of the
unit near the left-front and right-rear corners.
Only products in the VersaTools line can be mounted on
a VersaTools rack shelf.
3. Install blank panels (included with Extron part #60-190-xx,
optional with Extron part #60-604-xx) or other units on the
rack shelf.
VersaTools
Rack Shelf
Quarter Rack Width
False Front Face Plate
(2) 4-40 x 3/16"
Screws
Eighth Rack Width
False Front Face Plate
DIS TR IB UT ION A MP LIF IE R
Figure 1 — Mounting the MIX 301 on a VersaTools
rack shelf
Back of the rack installation
The MIX 301 can be conveniently mounted on the rear of a rack
by using the Extron back of the rack mounting kit (Extron part
#70-367-01). The back of the rack mounting kit allows the
MIX 301 to be vertically positioned.
1. Attach the two back of the rack mounting brackets to the
sides of the MIX using the four included mounting screws.
IPA T IP A
IPA T IP A
DIS TR IBU TIO N A MP LIF IER
MD A S ER IES DIS TRIB UTIO N A MPL IFIE R
Figure 2 — Mounting the MIX 301 on a standard
1U rack shelf