beautypg.com

Electrolux 40660 i User Manual

Page 11

background image

Operating Instructions

11

Adjust the water softener to the setting given in the table that corre-
sponds to the hardness of the water in the area where you live.

1

It is only possible to adjust the water hardness setting when a pro-
gramme is not running. If you have inadvertently started a programme
(an LED indicator is constantly illuminated), then the programme must
be cancelled by pressing the appropriate button.

0

1. The dishwasher must be switched off.

2. Manual setting:

Open the door on the dishwasher.

3. Remove the lower basket from the

dishwasher.

4. Turn the water hardness switch to 0

or 1.

5. Re-position the lower basket.

6. Electronic setting:

Press the water-softener and func-
tion buttons simultaneously and keep
them pressed.

7. In addition press the ON/OFF button.

8. The LED indicator for the water-softener button flashes.

9. Press the water-softener button again.

– The LED indicator for the water-softener button will be illuminated

continuously for an initial 5 seconds and then begin to flash.

– The number of flashes corresponds to the hardness setting.
– The sequence of flashes is repeated several times after a 5 second

pause.

10. Each time you press the water-softener button the hardness setting

will go up by 1.
(Exception: Hardness setting 1 follows hardness setting 5).
– If the hardness setting is changed, the LED indicator for the water-

softener button will confirm the change by remaining illuminated
continuously for 5 seconds and then flashing again.

– The number of flashes corresponds to the new hardness setting.
– The sequence of flashes is repeated several times after a 5 second

pause.

11. Once the hardness setting is correct, press the ON/OFF button.

The hardness setting is then saved.