Playtive Tri Scooter - Manual (Page 5)

5 GB
• When using the scooter, it is necessary to be
dextrous, to avoid falling or collisions, which
could lead to injury of the driver or of other
persons.
Avoiding material damages!
• Avoid water, oil, potholes and very rough
surfaces.
Assembly
1. Remove the pre-fitted nut and washer from the
rear axle (6). Now push the rear axle into
one of the rear wheels (4). Now slide a small
washer (13) onto the rear axle and then
slide the axle through the frame. Now place
the second small washer (13) onto the rear
axle and put the second wheel (4) on.
Tighten the wheel with the washer and the
nut (Fig. B).
2. Slide the insert for the frame (8) into the
upper opening of the frame. Slide the fork
and front wheel into the frame from below.
Push the lock pin on the fork inwards and
take care that it clicks into place securely into
the frame (Fig. C).
3. Move the large washer (12) followed by the
clamp (7) onto the fork. Take care that the
vertical groove in the fork points towards the
back (Fig. D).
4. Remove the pre-fitted nuts and washers from
the handlebar (3). Place the handlebar on
the steering column (5) and affix it with the
washers and nuts (Fig. E).
5. Slide the quick fastener (9) over the steering
column and slide the column into the fork
(Fig. F).
6. The screw of the quick fastener is affixed in
the upper pre-drilled hole. Secure the steering
column by locking the quick fastener and by
fastening the clamp (Fig. G).
Tighten all nuts and screws securely using the
tools provided and check for secure fit.
Adjusting the height of the
handlebar
The handlebar is adjustable to two
different heights. The article may only
be used when the lock button is clicked
into one of the two pre-drilled holes
provided and the handlebar is subse-
quently locked with the quick fastener
and the clamp!
1. Loosen the quick fastener and the clamp at
the steering column.
2. Pull the steering column upwards, until the
lock button clicks into one of the two
pre-drilled holes.
3. Secure the steering column by locking the
quick fastener and by fastening the clamp.
Use
Driving
Put one leg on the deck and propel yourself
forward by regularly pushing off with the other
leg. The scooter can be steered by moving
the handlebar, moving your weight and by a
combination of both.
Maintenance
Changing the wheels
Important!
Please observe the technical data.
Wheels with a different diameter can
change the handling characteristics
and may lead to endangering of the
user.
Never use wheels that cannot be fitted
properly. Never fit larger wheels than
the original wheels of the article.