Eureka 6998 Series - Manual (Page 9)

12 9
HEPA Filter
Check the HEPA filter with each disposable dust
bag change. Replace after every six bag changes
or when obviously dirty.
1. To change HEPA filter, pull out and down on
exhaust grille to open the filter cover.
2. Remove filter cover.
3. Pull out the used HEPA filter by using finger
tab.
4. Put in new HEPA filter. (Part number 60286)
5. Replace filter cover.
Filters
(continued)
1
2
MAX
MAX
Your new vacuum cleaner is equipped with a Cyclonic Bag Saver option.
To assemble the cleaner with this option follow these instructions,
otherwise follow the owner’s guide for assembly.
This accessory reduces the need for frequent bag changes. It does
not eliminate the use of a paper bag. To remove the Cyclonic Bag
Saver, follow the steps in reverse and reattach the large upper wand.
UNPACKING AND ASSEMBLING
Unpack and check that all the parts are included. The Cyclonic Bag
Saver consists of three main parts, see Fig.1:
1. Cyclonic Housing
2. Cyclone Dust Cup
3. Retaining Clip
Attach retaining clip onto the rear of the cyclonic cup as shown in
Fig. 1a.
Attaching the Cyclonic Bag Saver onto the vacuum
cleaner
NOTE: If the two long wands have already been assembled to the
powerhead, remove the long upper wand to assemble the
Cyclonic Bag Saver.
Your vacuum cleaner is equipped with three wands. Locate the short
wand.
Fig. 2a Line up the small hole at the top of the short wand with the
arrow on the front of the cyclonic housing. Push the short
wand into the top of the cyclonic housing until it clicks into
place. (You may need to rotate the wand slightly.)
Fig. 2b Attach the cyclonic dust cup onto the cyclonic housing. Place
the slot in the cyclonic dust cup over the tab on the cyclonic
housing. Then grasp the handle on the cyclonic dust cup,
and pivot the cyclonic dust cup up and over the ledge on the
cyclonic housing.
Fig. 3 Push the nozzle at the bottom of the cyclone unit into the
top of the long lower wand. Adjust the position of the cyclone
unit. Push the long lower wand into the powerhead unit. Plug
the powercord into the powercord retainer at the top of the
cyclonic housing, see Detail A. Attach the powertouch handle
following instructions in the owner’s guide.
Important Safety Information
- Do not vacuum surfaces which have been subjected to
inflammable solvents.
- Do not pick up any liquid.
- Do not pick up hot ashes which could cause a fire.
Emptying
Empty the dust compartment of the cassette after each use or when
the dust cup is filled up to the MAX level, Fig. 3. Detach the dust cup
by following the instructions in Fig. 2b in reverse.
Empty the contents into a waste container. To reattach the dust cup
again follow the described steps in Fig. 2b.
Maintenance
The Cyclonic Bag Saver can be washed in cold or warm water and a
mild detergent. Thoroughly dry the dust compartment with a soft towel
before using it again. If the cyclone unit clogs, use the vacuum cleaner
to unclog it.
1
2
3
Fig. 1a
Fig. 1
Fig. 2a
Fig. 3
Fig. 2b
Handle
Tab &
Slot
Nozzle
Long Lower Wand
Detail A
Powercord
Powerhead Unit