Electrolux EWB 85100 W - Manual (Page 9)

UNPACKING
2
1
UNTYING
A B
C
D
A
1
2 B
2
1
2
1
1
C
D
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture D.
WATER SUPPLY
Install the supplied water inlet hose at the
rear of your washing machine by proceed-
ing as follows. Do not reuse an old hose.
The water inlet hose can not be extended. If
it is too short, please contact the after-sales
service.
90 O 90 O 90 O
Open the water inlet tap. Check there are
no leaks.
DRAINAGE
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
ELECTRICAL CONNECTION
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 10 A for 230 V. The appliance
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
POSITIONING
Position the appliance on a flat and hard
surface in a ventilated location. Ensure the
appliance does not come into contact with
the wall or other furniture.
To move your appliance, proceed as fol-
lows:
Place it on its rollers
by pulling the lever
located at the base
of the appliance hard
from right to left.
Once the appliance
is in the desired po-
sition, push the lever
back to its original
position. Accurate
max
100 cm
min
70 cm
electrolux 9