Emotiva DMC-1 - Manual (Page 53)

Page 52 Page 53
TONE Menu
The Bass and Treble can be boosted or cut by up to 10 dB.
INPUTS Menu
These menus let you select which input you would like to
configure. Pressing the joystick right on each input brings
up a second menu which allows you to configure what
happens when each input is selected.
INPUT CONFIGURATION MENUS
(The example shows the DVD menu)
NAME - Use the joystick up/down, and left/right to change the display
name for any input, up to 9 characters. Move fully to the left after
entering the name.
GAIN TRIM - Use this to adjust all of your sources to play at
similar levels. To prevent overloading, the levels can only be
adjusted downwards. You should try and trim all the inputs
to be the same average level as your quietest source.
DEFAULT MODE - Set the input to a favorite surround
mode or stereo.
MAIN ZONE - Enable/disable the selected input in the
Main Zone. You can set up your system so any unused
inputs are not selectable. From the factory, the inputs are
enabled. If you choose to disable an input, then it will not
play in the Main Zone.
TRIGGER RELAY - The Trigger Relay can be set to turn
on whenever the input is selected. This could be used to turn on an
amplifier, video screen, lighting controls, etc.
ZONE 2 - Enable or disable the input for use in Zone 2. Sometimes
this is a useful idea to implement when a simple selection
is desired in the second zone (such as a patio, play room,
garage, or bedroom).
Note: The 8-Channel input menu is different from the other
menus as it allows you to select a specific video
input whenever the 8-Channel audio input is
selected. Also, this input only works in the MAIN
ZONE, not in ZONE 2.
DVD INPUT Configuration Menu Example
*See Note for 8-Channel Input Choices