Miomare 52798 - Manual (Page 6)

English
Mounting, switching on, malfunctions
Observe all of the instructions and warnings. Improper use or incorrect operation can lead to serious physical injury
(e.g. from electric shock or burning) and substantial material damage (e.g. from fire).
Storage and transport
Store and transport product in its original packaging only. Protect the product from mechanical stress, moisture, frost and dust.
Comes with:
Mirror cabinet, Mounting material, Bulb(s) not included!
Unpacking
Take all the parts out of the box and remove packaging. Lay them out on a soft surface e.g. carpet. Check all parts for any visible
damage.
Mounting and electrical installation
Mounting and electrical installation of the mirror cabinet/lighting must be carried out by a qualified electrician.
Switch off (or remove) the mains fuse before mounting and installing the light (see illus. p.2,A).
Make sure the power is not connected by using an appropriate electricity indicator.
1. Decide where you want to mount the mirror cabinet. Hold it against the wall and mark the four drill holes with a pen.
2. Drill 4 holes at the marked positions and insert dowels.
3. Release the top cover of the mirror cabinet by gently pushing in on the bottom of the cover and tilt it forward (see illus. p.2,B1-3)
4. Take the light unit out (press the clip on the back down) (see illus. p.2,C1-3).
5. Run the cable through the top and attach the mirror cabinet as follows: First turn both screws at the top in the wall so that they
protrude enough to be able to hang the cabinet easily. Make sure the cabinet is positioned properly on the wall. Once you have
hung the mirror cabinet on the wall, you can now screw in the 2 bottom screws tightly and then screw the top screws in fully as
well. To make installation easier we recommend removing the compartment floors (see illus. p.2,D1-3).
6. Connect the power cable to the designated terminal block inside the lamp: L / N and earth wire (see illus. p.2,D4).
7. Slide the light unit back on the rails until it clips into place at the bottom (see illus. p.2,D5)
8. Turn the bulb in a clockwise direction into the holder until it stops (see illus. p.2,E1-2).
9. Put the compartment floors back into the cabinet and shut the doors. The middle door is equipped with a touch-mechanism.
Press the bottom of the door in the middle to open and shut it (see illus. p.2,E6).
10. Mount the top cover of the mirror cabinet. Make sure the cover clicks into place and is firmly seated (see illus. p.2,E3-5).
11. Switch the fuse back on (see illus. p.2,F).
Switching on
Turn the lights of the mirror cabinet on and off with your mains switch. The lights of the mirror cabinet can also be switched on and
off with the built in switch.
Disposal of packaging
Dispose of the packaging material, sorting it according to type.
Keep packaging and wrapping away from children. Danger of suffocation!
Damage and malfunctions
In the event of malfunction or damage to the product, disconnect it permanently from your mains electricity supply and no longer
use it. Repairs should only be carried out by a specialist or in the service centre. Never attempt to repair the product yourself.
08/2010; Lidl - Block 4 ab LT37/10; BK46742; 52798, 52819, 52821, 52822, 52935 5/32