Safety information – Melinera Z31515A-BS User Manual
Page 4

4 GB/IE
Safety information
In the case of damage resulting from non-compliance
with these operating instructions the guarantee
claim becomes invalid! No liability is accepted for
consequential damage! In the case of material
damage or personal injury caused by incorrect
handling or non-compliance with the safety
instructions, no liability is accepted!
DANGER OF
DEATH AND ACCIDENTS FOR
TODDLERS AND CHILDREN!
Never leave children unsupervised with the
packaging material. The packaging material
represents a danger of suffocation. Children
frequently underestimate the dangers. Please
keep children away from the device at all times.
This device is not a toy and should not be played
by children. Children are not able to understand
the dangers that can occur when handling this
device.
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction con-
cerning use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230–240 V∼).
Before connecting to the mains, always check
the product for any damage.
Never use the product if you find damage of
any kind.
The connecting cable cannot be repaired! If the
cable is damaged, the product must be taken
out of use and disposed of in the proper way.
This article does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the LED rope
light
1
with wet hands.
CAUTION! RISK OF OVERHEATING! The
lamps in the fairy lights have a power input of
0.06 W each. This wattage not only produces
light, but also heat.
Do not operate the LED rope light
1
in the packaging or when it is
rolled up.
Ensure the rope light is mounted to provide
adequate heat-circulation.
Do not cover the rope light with blankets,
cushions, or similar heat insulating materials.
Use the lighting only with the parts described
in these instructions.
If the LED rope light
1
is not to be used for
any length of time (e.g. holidays), disconnect
it from the power supply.
After use, keep the LED rope light
1
in the
packaging to prevent unwanted damage.
Keep away from ponds and other water reservoirs.
Install the LED rope light
1
at least 2 metres
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light
1
outdoors, make
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The LED rope light
1
is protected against
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light
1
is not laid
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light
1
and make
sure it is laid down properly so that no one
walks or trips over it.
60117_mel_LED-Lichterschlauch_Content_VDE_FI_SE_DK_BE.indd 4
08.04.14 12:49