Melinera Z31515A-BS - Manual (Page 16)

16 GB/MT
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230–240 V∼).
Before connecting to the mains, always check
the product for any damage.
Never use the product if you find damage of
any kind.
The connecting cable cannot be repaired! If the
cable is damaged, the product must be taken
out of use and disposed of in the proper way.
This article does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the LED rope
light 1 with wet hands.
CAUTION! RISK OF OVERHEATING! The
lamps in the fairy lights have a power input of
0.06 W each. This wattage not only produces
light, but also heat.
Do not operate the LED rope light
1 in the packaging or when it is
rolled up.
Ensure the rope light is mounted to provide
adequate heat-circulation.
Do not cover the rope light with blankets,
cushions, or similar heat insulating materials.
Use the lighting only with the parts described
in these instructions.
If the LED rope light 1 is not to be used for
any length of time (e.g. holidays), disconnect
it from the power supply.
After use, keep the LED rope light 1 in the
packaging to prevent unwanted damage.
Keep away from ponds and other water reservoirs.
Install the LED rope light
1 at least 2 metres
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light 1 outdoors, make
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The LED rope light 1 is protected against
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light 1 is not laid
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light 1 and make
sure it is laid down properly so that no one
walks or trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The LED rope light 1 can be installed on all
normally inflammable surfaces with the enclosed
mounting parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or water
lines located where you wish to drill. Check with
a cable and pipe locator if necessary before
you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the LED rope light
1 . If you are in any doubt,
consult an electrical specialist for advice.
Do not use sharp and / or pointed objects such
as wire, nails or fasteners for mounting.
Do not attach any additional objects to the
LED rope light 1 .
Avoid excessive bending of the LED rope
light 1 . This can damage the insulation.
The bending radius of the rope must not fall
below the following value: rope diameter
between 10–14 mm: 2 cm.
Avoid excessive heating of the LED rope light 1 .
A maximum of two sections of rope may cross
or run parallel to each other.
60117_mel_LED-Lichterschlauch_Content_VDE_ES_PT.indd 16 08.04.14 12:49