Before first use removing the insulation strips, Operation, Replacing the batteries – Melinera Z30906A/Z30906B/Z30906C User Manual
Page 5: Cleaning and care, Disposal

5
GB
result. Never throw batteries into fire or water. 
The batteries might explode.
Avoid extreme environmental conditions and
temperatures as they may affect batteries e.g. 
above radiators. Otherwise the batteries are 
more likely to leak.
Exhausted or damaged batteries can 
cause caustic burns upon contact 
with the skin. To avoid this, always 
wear suitable protective gloves in these circum-
stances!
Avoid contact with the skin, eyes and mucous
membranes if fluid is leaking from a battery. If 
you come into contact with corrosive battery 
fluids, flush the affected area thoroughly with 
clean water and contact a doctor immediately.
Before inserting the batteries, clean the battery
contacts and the contacts of the battery com-
partment using a dry, fluff-free cloth.
Make sure you insert the batteries the right
way round (polarity). The correct polarity is 
shown inside the battery compartment.
Remove exhausted batteries from the device
immediately. Otherwise the batteries are more 
likely to leak.
 Batteries do not belong in household refuse!
 Every consumer is obliged to dispose of batteries 
properly in accordance with the regulations.
Keep batteries away from children. Do not
throw batteries into a fire. Never short-circuit 
them or take them apart.
If you disregard these instructions and advice,
the batteries may discharge beyond their mini-
mum voltage, thus increasing the chance of 
leakage. If your batteries leak, remove them 
from the device immediately to prevent it from 
being damaged.
Always replace all the batteries at once with
batteries of the same type.
Remove the batteries if you are not going to
use the device for an extended period.
The cord of this light set cannot be replaced. If
the cord is damaged the light set should be 
scrapped.
The light chain must not be electrically connected
to another light chain.
Before first use
Removing the insulation strips
Note: The device is supplied with the batteries 
already in place.
Before first use, pull the battery insulation strips
out from between the batteries and the battery 
compartment 
2
.
Operation
Press the ON / OFF switch
4
to switch on the
LED-illuminated decoration
1
.
Replacing the batteries
To replace the batteries follow the procedure
described in the figure.
Cleaning and care
Do not use solvents, such as petrol and the like,
as they could damage the device.
Clean the uneven surface with a feather duster
or narrow brush.
Disposal
The packaging is wholly composed of 
environmentally friendly materials that can 
be disposed of at a local recycling centre.
Contact your local refuse disposal authority for 
more details of how to dispose of your worn-out 
product.
