Melinera 103382-14-0х - Manual (Page 15)

15 GB/MT
The light automatically switches on in twilight
conditions and off again when normal outdoor
lighting conditions return.
Replacing the
rechargeable battery
The battery should be replaced every 12 months to
ensure optimum performance.
1. Separate the solar cell housing
5 from the lamp
shade 6 by moving it anti-clockwise (see Fig. A).
Switch off the lamp with the ON / OFF switch 1 .
2. For 103382-14-01 / 02 / 03: Open the
battery compartment lid of the solar cell
housing.
For 103382-14-04: Loosen the fastening
screws
2 by using a small cross head screw-
driver and then lever out the battery compart-
ment lid
3 of the solar cell housing 5 with
the help of a slot screwdriver (see Fig. B).
3. Exchange the old rechargeable battery 4 to a
new one, ensure that you do not damage the
wiring. Take care to the correct polarity, when
inserting the new rechargeable battery. The po-
larity is indicated in the battery compartment.
The new rechargeable battery has to have the
same technical data like the old one.
4. For 103382-14-04: Now again fasten the
battery compartment lid
3 , fasten the fasten-
ing screws 2 by using a small cross head
screwdriver. Slide the ON / OFF switch 1 to the
position ON.
5. Connect the solar cell housing 5 again to the
lamp shade 6 and then connect every part of
the solar lamp to each other (see Fig. D).
Charging the rechargeable
battery
Note that the solar garden light must be switched
on when the battery is charging.
The charging time of the battery when the solar cell
is used depends on the intensity of the sunlight and
the angle of incidence of the light on the solar cell.
Place the solar cell as perpendicular as possible to
the angle of incidence of the light. In this way you
will receive the highest light levels.
Maintenance and care
The light-emitting diodes cannot be replaced.
The solar lamp is maintenance-free, except for any
necessary change of battery.
Clean the solar lamp regularly with a dry, lint-
free cloth. Use a slightly dampened cloth to
remove more stubborn dirt.
Troubleshooting
Note: This appliance has delicate electronic com-
ponents. This means that if it is placed near an object
that transmits radio signals, it could cause interfer-
ence. If you notice that the device is malfunctioning,
remove any sources of interference from the area
of the device.
Note: Electrostatic discharges may cause device
to malfunction. In the event of such malfunctions,
remove the batteries briefly and reinsert them.
Error Cause Solution
The light will
not switch on
even though
the sun shone
on the lamp
all day. Artificial
sources of
light, e.g.
street lighting,
are interfering
with the lamp. Mount the lamp
in a place where
it cannot be dis-
turbed by other
sources of light.
The light does
not come on
or comes on
only briefly. The recharge-
able battery
is broken or
there was
not enough
daylight. Replace the re-
chargeable bat-
tery or mount
the lamp in a
place where it
can receive
more sunlight.
103382_mel_LED-Solarleuchte_content_ES_PT.indd 15 21.10.14 14:39