Electrolux U28190 - Manual (Page 26)

Water inlet
Connect the hose to a tap with a 3/4” thread.
Do not use previously used hoses for water
connection.
Installation should comply with local water authority
and building regulations’ requirements.
The appliance must be connected to a cold water
supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum distance of 5.02m
(16.5 ft) between the appliance’s inlet and the bottom
of the water storage tank.
Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring
nut again to prevent leaks.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system using one
of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the “U” piece” supplied.
P0021
P1088
Place the drain hose into your standpipe, which
should have an internal diameter of approximately
38mm thus ensuring there is an air break between
the drain hose and standpipe.
When discharging into a standpipe ensure that the
top of the standpipe is no more than 90cm (35.4'')
and no less than 60cm (23.6'') above floor level.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre.
The joining piece must have an internal diameter of
18mm.
If your drain hose looks like this (see below) you do
not require the “U” piece”. Just push the hose firmly
into the standpipe.
P1201
3 pin
Min.
60
cm
(23
.6”)
Max.
90
cm
(35
.4”)
P1200
30
cm (
12
")
38 mm (11.2”)
standpipe
diameter
“U” piece
supplied
P1199
26
New_12108_14108.qxp 12/12/2005 5:41 PM Page 26