Melinera Z28957A-BS - Manual (Page 4)

4 GB/IE/CY
Children or other individuals who do not know
or have no experience of handling this device,
or whose physical, sensory or mental abilities
are restricted, must not use the device without
supervision or instruction by an individual respon-
sible for their safety. Children must be supervised
in order to ensure that they do not play with
the device.
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage avail-
able is the same as the required operating volt-
age for the device (230–240 V∼).
Before connecting to the mains, always check
the product for any damage.
Never use the product if you find damage of
any kind.
The connecting cable cannot be repaired! If the
cable is damaged, the product must be taken
out of use and disposed of in the proper way.
This article does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the rope light
with wet hands.
CAUTION! RISK OF OVERHEATING! Do
not operate the rope light in the packaging or
when it is rolled up.
Use the lighting only with the parts described
in these instructions.
If the rope light is not to be used for any length
of time (e.g. holidays), disconnect it from the
power supply.
After use, keep the rope light in the packaging
to prevent unwanted damage.
This product is intended for use outdoors but
should be plugged into a socket which is located
in an indoor location (e. g. a shed, garage or
porch).
Sockets positioned outdoors for use with this
product should be of a type which is adequately
water proof for an outdoor location and should
be located at least 2.5 m from the nearest bady
of water or any location where water may collect.
If using the rope light outdoors, make sure it is
connected to a socket which is protected with
a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The rope light is protected against splashes of
water (IP44) as long as the socket meets the
minimum protection standard.
Make sure the rope light is not laid down in
areas where lawn mowers, trimmers, scissors or
similar cutting tools are used.
Do not pull the light chain cable and make sure
it is laid down properly so that no one walks or
trips over it.
If in any doubt about the safe installation or use
of this product, please consult a qualified elec-
trician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The rope light can be installed on all normally
inflammable surfaces with the enclosed mounting
parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or wa-
ter lines located where you wish to drill. Check
with a cable and pipe locator if necessary be-
fore you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the rope light. If you are in any doubt, consult
an electrical specialist for advice.
Do not use sharp and/or pointed objects such
as wire, nails or fasteners to mount the rope light.
Do not attach any additional objects to the
rope light.
Avoid excessive bending of the rope light. This
can damage the insulation.