Melinera Z30171-BS/Z31589-BS - Manual (Page 8)

8 GB/IE
Do not install with sharp fasteners or nails.
Always unplug the mains adapter 3 from the socket before
installation, dismantling or cleaning.
Never touch the light chain plug or the light chain itself with
wet hands.
The string lights must not be electrically connected to another
set of lights.
Use
Note: The light set has 6 parallel wires, each with five small lights
2 and one large light 1 . The distance between the wires is
approx. 16 cm.
Mount the small lights 2 on to the sockets of the bulbs.
Use the supplied suction cups 4 to hang up the light set.
Insert the plug on the end of the light set into the socket of the
mains adapter
3 . Secure the connection by pushing the
clamping nut on the lead over the plug and screwing it on to
the mains adapter.
Insert the mains adapter 3 into the mains socket. The light set
is now switched on.
Pull the mains adapter 3 out of the mains socket to switch off
the light set.
Note: The bulbs are connected in series. If one bulb is defective,
then all the bulbs of one wire may not light up.