EdgeStar AP410W - Manual (Page 13)

If this light is flashing, the internal condensate tank is full and the unit has shut
itself off. Empty the tank to restart the unit. See the Drainage section for more
information on performing this operation.
Buttons
1. “TEMP. UP” = Adjusts Temperature Up
This button raises the thermostat temperature setting. It only affects the operation
of the unit in Cooling mode.
2. “TEMP. DOWN” = Adjusts Temperature Down
This button lowers the thermostat temperature setting. It only affects the operation
of the unit in Cooling mode.
3. “SPEED” = Adjusts Fan Speed
Press this button to adjust the fan speed between High and Low settings.
4. “MODE” = Toggles Modes
Press this button to switch between modes- Auto, Cooling, or Fan.
5. “TIMER” = Turns Timer On/Off
Press this button to activate the timer. Each time you press this button, a time will
appear in the LED display (from 1 to 12 hours). The timer can be used to turn the
unit on or off.
To turn the unit on using the timer, make sure the unit is off. Press the “TIMER”
button until the desired number of hours appears in the LED display. After the
number of hours you selected elapses, the unit will turn on.
To turn the unit off using the timer, make sure the unit is on and operating as you
want it to. Press the “TIMER” button until the desired number of hours appears in
the LED display. After the number of hours you selected elapses, the unit will
turn off.
6. “ON/OFF” = Turns Unit On/Off
Press this button to turn the unit on and off.
Remote Control
Setting up the remote control
1. Remove the cover from the back of the remote control.
2. Insert 2 AAA batteries.
3. Point the remote control at the portable air conditioner (make sure the air
conditioner is plugged in) and press the button for the operation that you want.
Notes:
Point the remote control at the portable air conditioner when you are using the
remote. The remote control sensor is located under the little red square on the top of
the portable air conditioner.
When the remote control is used to change most settings on the portable air
conditioner, the portable air conditioner will emit a beep.
The maximum range for the remote control is 13 feet.
Remove the batteries from the remote control if you are not going to use it for several
weeks or more.
13