Meradiso Z30155 - Manual (Page 17)

19 GB/MT
Operation / Maintenance / Cleaning and care / Disposal
Fixing them on top of each other:
Remove the pillow 11 from one of the air beds
10 and place the other air bed 10 flush on top
of it (see Fig. E).
Close the buckles 4 on the side as described
above.
Fixing the beds side by side:
Place the two air beds 10 next to each other
so that the ends with the pillows 11 point in the
same direction (see Fig. C).
Close the buckles 4 as described above.
Maintenance
Mending airbed and pillow
Note: Minor damage may be repaired using the
supplied repair set
9 . Have any major damage
carried out at a specialist repair shop.
Note: Suitable adhesive can be obtained at spe-
cialist dealers.
CAUTION! RISK OF INJURY! Keep the glue
out of the reach of children. Avoid contact with skin.
Protect your eyes. Use protective goggles if neces-
sary. Do not inhale or eat the glue.
First let the air out of the product (see “Deflating
airbed and pillow”).
Clean the damaged area with alcohol.
Abrade the area around the site of the damage
with fine sandpaper.
Cut out a piece of the plastic film in the repair kit.
Note: Make sure that the patch largely overlaps
the edges of the leak.
Round the corners off and place the patch over
the leak or hole. Use a pencil to draw around
the edges of the patch.
Place the repair patch onto the damaged part.
Press the repair patch firmly down onto the
leak. You may have to place a heavy object
onto the relevant area.
Wait for 24 hours before you pump up the
product again.
Cleaning and care
Do not use corrosive or abrasive cleaning
agents.
Clean the flocked surface of the product using
a brush.
Clean the plastic surfaces with water and / or
a little mild soap solution.
Do not expose the product to extreme weather
conditions such as extreme temperature, wind
and rain.
Do not allow the product to be subjected to frost.
Ensure that the inside and outside of the product
are completely dry if you intend to store it
indoors for a long period. Failure to observe
this advice could result in the build-up of mildew
and mould.
Fold up the product with the flocked surface on
the inside.
Store the product in dark, dry place – out of
reach of children.
The ideal storage temperature is between
10 and 20 °C.
Make sure that the valve 3 , 8 is shut if you
wish to store the product for any length of time.
Do not allow sharp objects to come into con-
tact with the product while it is in storage.
Never powder the product with talcum.
Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Product identification:
Double air bed
Model no.:
Z30155
Version: 09 / 2011
68882_mer_Luftbett_Content_LB5.indd 19 19.07.11 17:37