Electrolux AG22H42STA User Manual

Page 26

01536

Weak or Dead Battery

Fully Charged Battery

02614

Hood

Headlight Wire
Connector

TO REMOVE HOOD AND GRILL AS-
SEM BLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of
tractor.

4. When replacing hood, be sure to re-

connect the headlight wire con nec tor.

ENGINE

TO AD JUST THROT TLE CON TROL
CABLE
The throt tle con trol has been pre set at the
fac to ry and ad just ment should not be nec-
essary. Check adjustment as de scribed
below before loosening cable. If adjust-
ment is necessary, see eingine manual.
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be nec-
essary. However, minor adjustment may
be required to compensate for differences
in fuel, temperature, altitude or load. If
the carburetor des need adjustment, see
engine manual.

TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the

backside of the grill.

3. Replace bulb in holder and push bulb

holder securely back into the hole in
the backside of the grill.

4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.

TO ATTACH JUMPER CABLES -
1. Connect one end of the RED cable

to the POSITIVE (+) terminal of each
battery(A-B), taking care not to short
against tractor chassis.

2. Connect one end of the BLACK ca ble

to the NEGA TIVE (-) terminal (C) of
fully charged battery.

3. Connect the other end of the BLACK

cable (D) to good chassis ground,
away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE
ORDER -
1. BLACK cable fi rst from chassis and

then from the fully charged battery.

2. RED cable last from both batteries.

0217

Keps Nut

Terminal
Guard

Terminal
Access
Door

Hex Bolt

Positive
(Red) Cable

Negative
(Black) Cable

REPLACING BATTERY

WARNING: Do not short battery ter mi -

nals by allowing a wrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected
fi rst to prevent sparking from ac ci den tal
grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect BLACK battery cable

then RED battery cable and carefully
remove battery from tractor.

4. Install new battery with terminals in

same position as old battery.

5. Reinstall terminal guard.
6. First connect RED battery cable to

positive (+) battery terminal with hex
bolt and keps nut as shown. Tighten
securely.

7. Connect BLACK grounding cable to neg-

ative (-) bat tery terminal with re main ing
hex bolt and keps nut. Tight en securely.

8. Close terminal access doors.
9. Close hood.