Electrolux E48GC76EPS - Manual (Page 2)

Gas Slide-In Cooktop
E48GC76EPS
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca
E48GC76EPS 01/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A.
48" Gas Slide-In Cooktop Specifications
• Product Weight – 190 Lbs.
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.03 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded for
safe operation.)
• Amps @ 120 Volts = 0.25 Amps
• Always consult local and /or national electric and gas codes.
• Cooktop ships with 3/4" factory regulator.
• LP Gas conversion kit supplied.
• Plan installation to have electrical connection, gas shutoff valve, and
pressure regulator accessible from front of cabinet. Locate 120V
grounded outlet and gas supply in a 30" W x 15-1/2" H area on rear wall,
10" above floor and 6" to right from center of cooktop.
• Overhead cabinetry should not exceed a 13" maximum depth.
• Allow 30" minimum clearance between top of cooktop and bottom of
unprotected wood or metal overhead cabinetry.
• Absolute minimum horizontal distance between overhead cabinets
installed to either side of appliance must be no less than maximum width
of appliance.
• Allow 24" minimum clearance when bottom of wood or metal overhead
cabinet is protected by not less than 1/8" flame-retardant millboard
covered with not less than No. 28 MGS sheet steel, 0.015" stainless
steel, 0.024" aluminum or 0.020" copper.
• Allow 2-1/2" minimum clearance between rear edge of cooktop and
nearest combustible surface above countertop. If required clearance
cannot be maintained, then optional stainless steel backsplash or
noncombustible backsplash material must be used – otherwise
installation will require custom cabinet and countertop dimensions.
• Allow 10" minimum clearance from edge of cooktop to nearest
combustible wall on either side of unit.
• It is recommended that drawers not be used beneath cooktop.
• To reduce risk of fire when using overhead cabinetry, install vent hood
that projects horizontally a recommended minimum of 5" beyond bottom
of cabinets.
• Gas Slide-In Cooktop model E48GC76EPS is NOT approved to be used
over any Electrolux ICON
® Single Wall Oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
Optional Accessories
• 9" Stainless Steel Backsplash – (PN # ACCBG09-48SI).
• Black Gas Valve Knob – (PN # 318313302).
1" min.
22"
3"
min.
25"
Support
platform
1 1 /
2
" typical
countertop
edge
10" min. to
nearest combustible wall
(either side of unit)
7 3 /
4
"
46"
48"
24" Opening to
route gas and
electrical supply
48" min.
13"
max.
cabinet
depth
18"
min.
30" min. for
unprotected cabinet
24" min. for
protected surface
Side inset 5 /
8
"
7 3 /
4
"
Optional 9" stainless
steel backsplash
(attaches to wall)
48"
26 1 /
2
"
1 /
2
"
* If 2 1 /
2
" clearance can not be maintained, then optional
stainless steel backsplash or noncombustible backsplash
material must be used – otherwise this installation will
require custom cabinet and countertop dimensions
2 1 /
2
" min. required distance between rear
edge of cooktop and nearest combustible
surface above countertop*