Crivit DS-MULTIX301 - Manual (Page 16)

18
chinstrap must sit comfortably under the chin
as far back towards the neck as possible .
Fasten it as tight as possible . The right degree
of tension is reached once you find it difficult
to insert your finger between the chinstrap and
neck, yet finding it easy to breath and swallow .
Make sure that the helmet sits securely once
the retention system is on . Make sure that the
helmet does not restrict your movements, e .g .
when turning your head to look behind you .
• Make sure the helmet carries a sticker certify-
ing homologation .
Maintenance and Care
Regular maintenance and care contributes to
safety and maintaining the helmet .
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet .
• Only use water and pH balanced soap.
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e .g . dead insects, dirt, sand, dust etc )
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth .
• When the visor gets wet (e.g. rainwater) it
should always be wiped with a soft cloth .
GB
Winter Collar
To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (14) can be
replaced with the supplied winter collar (15) .
Removing the standard collar
Pull the one-piece standard collar out of the
helmet (see Fig . J) .
Inserting the Winter Collar
First attach the plastic clip in the centre at the
back part of the helmet in the groove between
the outer shell and the padding .
Once the plastic clip is completely locked, press
the complete winter collar again firmly onto the
padding of the helmet (see Fig . K) .
Visor Replacement
If the pre-mounted visor (7) is damaged or
severely scratched, you can exchange it with the
replacement visor .
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (see Fig . L) .
• Pull the red visor-locking lever and remove the
visor (see Fig . M) .
Inserting the Visor
• Place the replacement helmet on the hold-
down device and observe the correct position-
ing in the process (fully opened) (see Fig . L) .
• Pull the red visor-locking lever and place the
visor appropriately (see Fig . N) .
• Allow the replacement visor to snap in and
close the visor .
Selecting the correct
helmet size
• Choose your helmet by measuring the circum-
ference of your head with a flexible tape meas-
ure . Always try on a couple of different sizes
before buying a close fitting helmet . When
wearing the helmet, the skin of your temples
should ideally move with it .
• Make sure that the helmet does not move
around when the retention system is open .
• The retention system must be set securely. The
Size table
Size Head circumference
S 55 – 56 cm
M 57 – 58 cm
L 59 – 60 cm
XL 61 cm