Visor replacement, Selecting the correct helmet size, Maintenance and care – Crivit DS-MULTIX301 User Manual
Page 8

11
12
Winter Collar
To reduce the wind inlet at the bottom of the helmet
during periods with very cold temperatures, the pre-
installed standard collar ( 16 ) can be replaced with
the supplied winter collar ( 15 ).
Removing the standard collar
Pull the one-piece standard collar out of the helmet
( see Fig. K ).
Inserting the Winter Collar
First attach the plastic clip in the centre at the back
part of the helmet in the groove between the outer
shell and the padding.
Once the plastic clip is completed locked-in, press the
complete winter collar again firmly onto the padding
of the helmet ( see Fig. L ).
Visor Replacement
If the pre-mounted visor ( 9 ) is damaged or severely
scratched, you can exchange it with the replacement
visor.
Removal of the Visor
- Slide the visor into the highest position (fully opened)
( see Fig. M ).
- Pull the red visor-locking lever and remove the visor
( see Fig. N ).
Inserting the Visor
- Place the replacement helmet on the hold-down
device and observe the correct positioning in the
process (fully opened) ( see Fig. M ).
- Pull the red visor-locking level and place the visor
appropriately ( see Fig. N ).
- Allow the replacement visor to snap in and close the
visor.
Selecting the correct helmet size
- Choose your helmet by measuring the circumference
of your head with a flexible tape measure. Always
try on a couple of different sizes before buying a
close fitting helmet. When wearing the helmet, the
skin of your temples should ideally move with it.
- Make sure that the helmet does not move around
when the retention system is open.
- The retention system must be set securely. The
chinstrap must sit comfortably under the chin as far
back towards the neck as possible. Fasten it as tight
as possible. The right degree of tension is reached
once you find it difficult to insert your finger between
the chinstrap and neck, yet finding it easy to breath
and swallow. Make sure that the helmet sits securely
once the retention system is on. Make sure that the
helmet does not restrict your movements, e.g. when
turning your head to look behind you.
- Make sure the helmet carries a sticker certifying
homologation.
Maintenance and Care
Regular maintenance and care contributes to safety and maintaining the helmet.
Cleaning of the Helmet
- Never use solvents, petrol or other detergents when cleaning the shell and interior of your
helmet.
- Only use water and pH balanced soap.
Visor care and cleaning
- After using the helmet, with a soft cloth, lightly wipe off any grime (e.g. dead insects, dirt,
sand, dust etc.) from the visor and then fully wipe it clean using a dry soft cloth.
- When the visor gets wet (e.g. rainwater) it should always be wiped with a soft cloth.
- When cleaning the visor, never use any petroleum-based solvents or detergents containing
abrasives.
Cleaning of the Cheek Pads, Acoustic Pads and Inside Pads
- Hand wash below 30° C.
- Allow to dry at room temperature.
- Avoid sources of heat.
- When not in use, store in a dry, well ventilated place.
Size table
Size
Head
circumference
S
55 – 56 cm
M
57 – 58 cm
L
59 – 60 cm
XL
61 cm
K
L
M
N