Electrolux LAVAMAT 62800 - Manual (Page 16)

16
Interrupting a programme/adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
START/PAUSE button. It is then re-started by pressing the START/
PAUSE button again.
• To stop the washing machine before the programme has ended, turn
the programme knob to OFF. Important! Be careful if there is water
in the appliance!
Adding washing
It is possible to add washing, as long as the DOOR light is lit green.
1. Press the START/PAUSE button. The door can be opened.
2. Shut the door and press the START/PAUSE button again. The pro-
gramme continues.
End of the wash cycle/removing the washing
At the end of the programme, END lights up on the programme
progress display. The door can be opened as soon as the DOOR indicator
is lit green.
1. Open the loading door and remove the washing.
2. Turn the programme knob to OFF.
3. Close the water valve.
4. After washing, pull out the detergent drawer a little to enable it to dry
out. Keep the loading door very slightly open so that the washing ma-
chine can air.
If RINSE HOLD has been selected:
After the rinse hold, END lights up on the programme progress display.
The water must first be drained:
– Either turn the programme knob to OFF, then to DRAIN and press the
START/PAUSE button (the water is drained without spinning),
– or turn the programme knob to OFF and then to SPIN. Change the
spin speed if necessary and press the START/PAUSE button (the water
is drained and the washing spun).