Kichler 300140 - Manual (Page 10)

9
Fig. 18
Fig. 19
Step 1. Attach the lamp to the lamp holders
applying even pressure to the lamp at each
lamp holder. The lamp will pop into place.
NOTE: Sometimes it helps to open the lamp
holder by lifting the end. This enlarges the
holder allowing the lamp to pop into place
easier. (Fig. 19)
Step 2. Take the four pin wire connector from
the ballast assembly and push it into the
receptacle located on the fluorescent lamp.
Step 3. Raise the glass shade against the light
plate and turn clockwise until snug. Do Not
Overtighten. (Fig. 19)
12. INSTALLING THE LAMP AND
GLASS SHADE
Screws
Lamp
Lamp holder
Light plate
Connection plug
Light plate
Lamp ballast
assembly
Wire connectors
Glass
shade
11. INSTALLING THE LAMP BALLAST
ASSEMBLY
NOTE: Before continuing installation, confirm
that the power is still turned off at the main
circuit breaker or by removing the correct fuse.
Turning the power off using a wall switch is not
sufficient to prevent electrical shock.
Step 1. Loosen the two mounting screws on
the light plate then remove and save the third
screw.
Hold the Lamp Ballast Assembly close to the
light fixture and connect the white wires from
the Ballast and the fan by pushing the
connectors together. Follow the same
procedure with the black wires. (Fig. 18)
Step 2. Tuck the connections neatly into the
light plate. Place the key holes on the ballast
assembly over the 2 screws previously
loosened from the light plate, turn the ballast
assembly until it locks in place at the narrow
section of the key holes. Secure by tightening
all three screws. (Fig. 18)