Kichler 300016 - Manual (Page 9)

8
10. INSTALLING THE MOUNTING PLATE
1. Loosen the two screws on the mounting ring
attached to the motor shaft and "remove" and
save the third screw. (Fig. 15)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
Fig. 15
Mounting
plate
Mounting ring
Screws
52" Canfield Select
TM
Fig. 16
11. INSTALLING THE LIGHT FIXTURE
1. Remove the plastic plug from the center of
the switch housing. Attach the light kit to the
switch housing by feeding the light kit wires
(black & white) through the hole in the center
of the switch housing, then screw the light
fixture stem into the center hole. On the inside
of the switch housing, place a lock washer and
nut on the light fixture stem and tighten.
(Fig.16)
2. Locate the white and blue wires inside the
switch housing labeled FOR LIGHT.
Attach the wires from the light kit to the wires
inside the switch housing by pushing the
polarized connections together.
- White wire to White wire
- Black wire to Black wire
Wire connector
Light kit
assembly
Nut
Lock washer
Switch housing
Plug