Kichler 300138 - Manual (Page 11)

10
Fig. 20
Fig. 21
Fig. 22
14. OPERATING INSTRUCTIONS
Remove the battery compartment cover on the
back of the CoolTouch™ Transmitter and
insert both batteries provided. Make sure the +
sign is facing up.
Take care during this procedure NOT TO
move the frequency dip switches inside this
compartment. The settings MUST remain the
same as the settings on the receiver for proper
communication with the control system.
It's a good idea to remove these batteries if
your fan is not used for extend periods of time,
(months).
13. INSTALLING THE BATTERIES
Carlson TM
Slide switch
Restore power to ceiling fan and test for
proper operation.
A.
, , and buttons:
These three buttons are used to set the
fan speed as follows:
= High speed
= Medium speed
= Low speed
B. button:
This button turns the fan off.
C. The " " button: turns the light fixture On
or Off. Press and release once for either
On or Off.
DO NOT substitute Incandescent Lamps for
Fluorescent Lamps. You will damage your fan.
This control is designed for use with
"Fluorescent Lamps". It is NOT designed to
control dimming of the light fixture.
This control system is NOT designed to
"Reverse" the rotation of the blades. To set
the fan blades in reverse, the reverse slide
switch is located on the top of the Motor
Housing. See Fig. 22