Kichler 78202 - Manual

1) Remove frame from mirror by removing two screws with
rubber washers on each side of frame. (Total of four screws
with rubber washers.)
2) On inside of frame remove screws in outlet box cover.
Remove outlet box cover from frame.
3) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF” position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room that
you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the OFF” position.
4) Determine desired location for mirror on mounting surface.
5) Holding frame up against mounting surface at desired location,
mark the holes at each corner of frame on mounting surface,
making sure the mounting strap hole pattern aligns with the
junction box.
6) Drill holes in mounting surface at marks to accommodate
wall anchors.
7) Push wall anchors into holes and tap until flush with wall.
6) Place frame up against mounting surface.
8) Pull outlet box wires through hole in center of frame.
9) Align holes in each corner of mirror frame with holes in wall
anchors.
10) Thread mounting screws through holes near center of frame
that match up with holes in outlet box. Tighten mounting
screws.
NOTE: Make sure holes in each corner of frame remain
aligned with holes in wall anchors.
11) Thread screws into holes in mirror frame and into wall
anchors. Tighten screws to secure mirror frame to mounting
surface.
12) Wrap supply line ground wire around ground screw located
in center of frame.
13) Connect uninsulated fixture ground wire to outlet box ground
wire with wire connector. (Not provided.) After following the
above steps. Never connect ground wire to black or white
power supply wires.
14) Make wire connections (connectors not provided.) Reference
chart below for correct connections and wire accordingly.
15) Place outlet box cover over hole in center of frame. When in
place, round rubber plug on outlet box cover should be
located at the bottom of the cover. Wires should extend
from outlet box cover under round plug.
IMPORTANT: DO NOT push wires back into outlet box.
Wire connections should remain inside mirror frame.
(REF. FIG 3.)
16) Thread screws into holes in outlet box cover.
17) Raise mirror up to frame on mounting surface.
18) Fit two brackets on one side of back of mirror inside one
side of frame.
19) Push other side of mirror towards frame. Fit remaining two
brackets on back of mirror inside frame.
20) Thread one screw with rubber washer into each hole on
sides of frame. Carefully tighten screws to secure mirror to
frame.
FRAME
SCREW
Date Issued: 7/12/13 IS-78202-US
WALL ANCHOR
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
MIRROR
FRAME
OUTLET BOX COVER
FRAME
1
2
3
OUTLET BOX COVER
4