How to use, Routine maintenance – Electrolux Z2250 series User Manual
Page 6
How To Use
(continued)
NOTE: Do not place the cleaner
on furniture or steps for
any period of time as the
brush roll may cause
damage. Place the cleaner
on the floor with the handle
in the upright/storage
position while using the
accessories. Do not allow
the cleaner to tilt forward
or to the side when using
accessories. This will
prevent the unit leaning
ans causing possible
damage to carpets or
floors.
1. To use accessories remove hose
from hose retainer on back of
cleaner by lifting up and twisting.
2. Place desired accessory onto
end of hose or crevice nozzle.
•
Turn ridge end to center.
•
Push tubes together.
•
Grasp both tubes near ridges.
Dusting/Upholstery Brush
is for furniture, blinds,
books, lamp shades, shelves, curtains, draperies, cushions
and fabrics.
Crevice Nozzle
cleans corners, stairs, skirting boards, and
between cushions.
Nested extension tubes
to add reach (on some models).
•
Pull apart.
Dusting/
Upholstery
Brush
Crevice
Nozzle
Routine Maintenance
CAUTION: Turn off the switch and unplug the electrical
cord before routine maintenance. Never operate
the vacuum cleaner without the dustbag or filter
assembly in place.
NOTE: Due to the powerful motor fitted to this vacuum,
you may notice a higher level of noise than that
of your previous model, and that it will pick up
considerably more than your old model. You may
need to change the dust bag more frequently as a
result of this better pickup. When vacuuming using
carpet fresheners or cleaners, powder, plaster
dust, or similar fine substances, the dustbag and
filters will require more frequent maintenance.
The instructions in this booklet serve as a guide to routine
maintenance. To avoid unnecessary service calls, check the
dustbag, filters, belt, and brushroll often.
Removing the Dustbag ES82:
(Alternate bag is E82)
Remove dustbag cover.
Grasp dustbag and pull from
cleaner.
Shake filter to remove excess dust. If necessary, the
filters may be cleaned by vacuuming with another
cleaner.
Check the
filters each time the dustbag is changed.
Clean or replace as needed.
6
remove
install
NOTE: Frequent cleaning of
the filters will maintain
maximum efficiency of
your cleaner. The foam
and pleated filters should
be removed for frequent
washing and can be used
in rotation with extra
filters (available through
Electrolux Helpline) to
ensure clean, dry filters
are always ready for use.
EF82
HEPA
Filter
EF1
Motor
Filter