Electrolux 75100 GA - Manual (Page 15)

15
Starting up and temperature regulation
☞
1. Insert the plug into the plug socket.
2. Press ON/OFF button.
The green mains pilot indicator illuminates. A warning tone sounds and
the flashing red warning light indicates that the required storage tem-
perature has not yet been reached.
3. Press the WARNING OFF button to switch off the warning tone.
4. Press either the „+“ (WARMER) or „-“ (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
5. Set the required temperature by pressing the „+“ (WARMER) or „-“
(COLDER) buttons (see section "Temperature setting buttons"). The
temperature display will immediately show the changed setting. With
each further press of one of the two buttons, the DESIRED tempera-
ture is adjusted by one display field.
The temperature is fixed to -18°C.
From a food safety point of view -18°C should be considered suffi-
ciently cold for storing food in the freezer.
6. Once the required temperature has been set, after a short period
(approx. 5 sec.) the temperature display will change and again indicate
the current ACTUAL temperature inside the fridge. The display will
change from flashing to continuous illumination.
The compressor will start and then run automatically.
Information! When the setting is changed, the compressor does not
start immediately if automatic defrosting is currently taking place.
Important! Wait until the freezer compartment has reached a temper-
ature of
-18°C before storing frozen food.