Electrolux EWF 127112 W - Manual (Page 18)

44 electrolux care and cleaning
• Open the pump door.
• Place a containfer close to the pump
to collect any spillage.
• When no more water comes out, unscrew
the pump cover and remove it. Always
keep a rag nearby to dry up spillage of
water when removing the cover.
• Remove any objects from the pump
impeller by rotating it.
• Screw the pump cover fully in.
• Close the pump door.
Warning!
When the appliance is in use and
depending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during a
wash cycle, always wait until the
appliance has finished the cycle, and is
empty. When replacing the cover, ensure
it is securely retightened so as to stop
leaks and young children being able to
remove it.
Cleaning the water inlet filter
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged.
It is therefore a good idea to clean it
from time to time.
Turn off the water tap. Unscrew the water
inlet hose. Clean the filter using a hard
bristle brush. Tighten up the inlet hose.
The dangers of freezing
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the inlet hose in a
bowl placed on the floor and let water
drain out.
• Screw the water inlet hose back on.
• When you intend to start the machine
up again, make sure that the room
temperature is above 0°C.
Important!
Every time you drain the water through
the emergency emptying hose you must
pour 2 litres of water into the main wash
compartment of the detergent drawer
and then run the drain programme. This
will activate the ECO VALVE device
avoiding that part of the detergent
remains unused at next washing.
126.2931.37…EWF 127112 W:- 12/07/10 16:46 Página 44