Echo SHR-210 - Manual (Page 10)

- 10 -
MAINTENANCE AND CARE
- ALWAYS KEEP THE MACHINE CLEAN -
Carburetor
Case
Air cleaner cover
Filter
AIR FILTER
• Check before every use.
• Remove fi lter cover.
- Remove wing nut.
• Brush off dust lightly or wash in a non-infl am-
mable solvent if necessary. Dry well before
reinstalling.
0.6 - 0.7 mm (0.024 - 0.028 in.)
SPARK PLUG
• Clean or replace the plug if fouled with heavy
or oily deposits. Replace the plug if the center
electrode is worn or rounded at the end.
- The standard spark gap is 0.6 to 0.7 mm
(0.024 to 0.028 in.).
- Correct the spark gap if it is wider or narrower
than the standard gap.
• Fastening torque = 15 to 17 N • m
(130 to 145 in • lb.)
CHECK FUEL SYSTEM
• Check before every use.
• After refueling make sure fuel does not leak or
exude from around fuel pipe, fuel grommet or
fuel tank cap.
• In case of fuel leakage or exudation there is a
danger of fi re. Stop using the machine imme-
diately and request your dealer to inspect or
replace.
NOTE
Federal EPA regulations require all model year
2012 and later gasoline powered engines produced
for sale in the United States to be equipped with a
special low permeation fuel supply hose between
the carburetor and fuel tank. When servicing
model year 2012 and later equipment, only fuel
supply hoses certifi ed by EPA can be used to
replace the original equipment supply hose. Fines
up to $37,500 may be enforced for using an un-
certifi ed replacement part.