Excalibur electronic Do It Yourself Workbench EI-PT1013 - Manual

The Do It Yourself Workbench drill requires 2 AA batteries, not
included. Using a Phillips screwdriver,
remove the battery cover from the drill
and insert the batteries as shown. Make
sure to match the polarity. Replace the
battery cover securely.
• Batteries should be installed and
replaced only by an adult.
• Do not mix alkaline, standard (carbon-
zinc) or rechargeable
(nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Do not use rechargeable batteries.
• Remove exhausted batteries from the unit.
• Do not short circuit battery terminals.
• Remove batteries and store them in a cool, dry place when not in use.
• To avoid explosion or leakage, do not dispose of batteries in a fi re
or attempt to recharge alkaline or other non-rechargeable batteries.
• Use only batteries of the same type and equivalency.
Userʼs Manual for
Do It Yourself Workbench
The Do It Yourself Workbench has 49 pieces. 41 pieces are used to
put together the Do It Yourself Workbench
D
O
I
T
Y
OURSELF
W
ORKBENCH
S
ET
-U
P
D
O
I
T
Y
OURSELF
W
ORKBENCH
P
IECES
B
ATTERY
I
NSTALLATION
& I
NFORMATION