Excalibur electronic IBLASTER 187 User Manual
Page 7
make sure an iPod is not docked
in the iBlaster Clock Radio.
Plug one end of the audio
patch cord (included) into the
headphone or
LINE
-
OUT
jack on
your device and the other end of
the patch cord into the iBlaster
Clock Radio
LINE
-
IN
jack, locat-
ed on the back of the unit.
Press the iPod button on the
iBlaster Clock Radio (or
PLAY
/
PAUSE
button on the
remote). The
AUX
icon will
appear, indicating
AUX
playing
mode.
Turn on and play your device.
Use the
VOLUME
knob on the
left side of the unit to adjust the
volume.
To turn
OFF
the unit, press the
ALARM RESET
/
POWER OFF
but-
ton (or the
POWER ON
/
OFF
but-
ton on the remote). Be sure to
turn off your device as well.
Listening to Radio
To listen to the radio, first
fully extend the
FM
antenna wire
to improve reception.
NOTE: Do not strip, alter or
attach to other antennas. The
AM
antenna loop should be
placed up to 12 inches away
from the unit for best reception.
You can also rotate the
AM
antenna loop to improve recep-
tion.
To listen to the radio, first
press the
RADIO
button on the
iBlaster Clock Radio or on the
remote control. The radio fre-
quency will appear on the top
right corner of the display.
Press the
AM
/
FM
button on the
iBlaster Clock Radio or on the
remote control to select
AM
or
FM
radio stations.
Turn the
SETTINGS
knob on
the iBlaster Clock Radio or the
>>
or
<<
button on the remote
control to find your desired sta-
tion.
Turn the
VOLUME
knob on the
iBlaster Clock Radio or the
VOL
+
or
VOL
-
buttons on the
remote control to adjust the
VOL
-
UME
.
To turn the radio
OFF
, press
the
ALARM RESET
/
POWER OFF
button on the iBlaster Clock
Radio or the
POWER ON
/
OFF
but-
ton on the remote control.
Connecting your iBlaster
Clock Radio to external
equipment
You can connect the iBlaster
Clock Radio to another line-
level device, such as an amplifi-
er or recording device through
the
LINE
-
OUT
jack located at the
back of the unit. The
VOLUME
setting on the iBlaster Clock
Radio does not affect the line
level. Adjust the
VOLUME
through the device you connect
to.
You can connect your iBlaster
Clock Radio to your television
by using the
OUTPUT
terminals
on the back of the unit. Before
connecting, be sure to set your
iPod video to television. The
OUTPUT
terminals output the
video and audio signals shown
on the television.
If your television has an
S
-
VIDEO INPUT
terminal, connect
your iBlaster Clock Radio to it.
If not, connect it to the video
terminal, as shown in Figure 9.
Figure 9: Connecting your iBlaster Clock Radio to external equipment
12
13