beautypg.com

Sticking the seal in the rabbet, Sticking on the seal – Electrolux 66331KF-N User Manual

Page 25

background image

25

Installation Instructions

Sticking the seal in the rabbet

Clean the rabbet in the work surface.

Stick the one-sided self-adhesive sealing tape supplied onto the upper surface

of the rabbet along the edges of the cut-out section.

Cut the sealing tape into four pieces relating to the length of the edges of

the rabbet.

For the four corners of the rabbet the ends of the sealing tapes must be cut

into mitres. Do not stick the ends over one another.

Stick the sealing tape flush into the corner of the rabbet, so that no silicon

compound can get under the glass ceramic when grouting.

Don’t stretch the tapes when sticking them on.

If installing flush with the work surface, use sealing tape with dimensions

10x2mm.

Sticking on the seal

Clean the worktop around the cut-out area.

Stick the single-sided adhesive sealing tape provided on the underside of the

hob around the outside edge ensuring that it is not stretched. The two ends

of the tape should join in the middle of one side. After trimming the tape (al-

low it to overlap by 2-3 mm), press the two ends together.

If installing proud of the work surface, use the sealing tape with dimensions

6x2mm.