Powerplus POWXG8250 SPREADER 23KG EN - Manual (Page 2)

POWXG8250
EN
Copyright © 2014 VARO P a g e | 2 www.varo.com
WALK BEHIND SPREADER
POWXG8250
1 PARTS DESCRIPTION (FIG. A)
1. Hex bolt M6x60 (2pcs)
2. Hex bolt M6x50 (2pcs)
3. Hex bolt M6x45 (3pcs)
4. Hex bolt M6x40 (2pcs)
5. Hex bolt M6x35 (4pcs)
6. Hex bolt M5x45 (1pc)
7. Screw M4x20 (1pc)
8. Screw ST6.3x38 ( 4pcs)
9. Lock nut M5 (1pc)
10. Flat washer Ø6 (1pc)
11. Lock nut M6 (13pcs)
12. Handle spacer (1pc)
13. Cotter pin Ø5x36 (2pcs)
14. Axle bushing (2pcs)
15. R pin (1pc)
16. Flat washer Ø16 (5pcs)
17. Wheel assembly frame (2pcs)
18. Upper handles (2pcs)
19. Handle shaft (1pc)
20. Frame (1pc)
21. Rain cover (1pc)
22. Impeller (1pc)
23. Crossover tube (1pc)
24. Hopper screen (1pc)
25. Wheel (2 pcs)
26. Hopper (1pc)
27. Gear & axle assembly (1 pcs)
28. Gauge & lever assembly (1 pc)
29. Frame brace (2 pcs)
2 GENERAL SAFETY RULES
 If your spreader does not spread evenly, be sure the FRONT on the gear points to the
front of the spreader. The impeller must turn clockwise. Reversing the gear will cause the
impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer stuck
on the impeller blades will cause uneven spreading.
 Your spreader is designed to be pushed at three miles per hour, which is a brisk walking
speed. Slower or faster speeds will change the spread patterns. Wet fertilizer will also
change the spread pattern and flow rate. Clean your spreader thoroughly after each use.
Wash between the shut off plate and bottom of the hopper.
3 ASSEMBLY
3.1 Figure 1
Turn the hopper upside down and attach the frame using four screws ST6.3x38.
3.2 Figure 2
 Slide the impeller, the swivel axle fix plate and the swivel axle bushing onto the vertical
shaft of gear & axle assembly.
 Insert the screw M4x20 through the impeller and the top of the vertical shaft.
3.3 Figure 3
 Find the two wheel assembly frames.
 Connect the right & left wheel assembly frames with the frame by bolts M6X60, secure
with lock nut M6.
 Connect the two ends of the cross tube with the right & left wheel assembly frames by bolt
M6X40, secure with lock nut M6.
 Connect the cross tube with the shaft support plate by bolt M6X35, the big flat washer Ø6
and lock nut M6.
3.4 Figure 4
 Attach one end of each frame brace to the outside of the hopper frame assembly by using
the bolt M6x35 and M6 lock nut.
M4X20