General instructions, Adjustment, Using adjustable handle (fig c/d) – Powerplus POWXG8010LI GRASS TRIMMER 18V LI-ION ONE FITS ALL EN User Manual

Page 8: Adjusting shaft length(fig. e), Adjusting cutting head angle (fig. f), Operation, Cutting and edging (fig. g)

POWXG8010LI

P a g e

| 8

www.varo.com

7.4

General instructions:

Regarding the battery, in order to maintain the long service life of the battery, always follow the
instructions below:
 The tool will automatically be switched off when the battery voltage is low. The battery

must then be recharged before the tool can be used again.

 Always recharge the lithium-ion battery prior to any prolonged period of non-use, i.e. before

storing the tool away in autumn.

 The charging time is 1,2 hours for a battery that is completely empty.



The lithium-ion rechargeable battery can be charged at any charge level and charging can
be interrupted at any time without damaging the battery (no memory effect)

8 ADJUSTMENT

8.1

Using Adjustable Handle (fig C/D)

The adjustable handle (4) can be set in various positions:
 To change the position undo the handle knob (3) and move the adjustable handle (4)
 Tighten the handle knob (3) securely to fix the adjustable handle (4) in the desired position.

8.2

Adjusting shaft length(fig. E)

 Loosen the adjustment collar (5)
 Pull the shaft out to increase, or push the shaft in to decrease the height/length.
 Retighten the collar (5).

8.3

Adjusting cutting head angle (fig. F)

The trimmer has 3-adjustable working angles. This allows you to easily reach hard to reach
areas in your garden.
 Press the lock button
 Adjust to the desired working angle (the handle noticeable snaps into places)

While working, the cutting head should be tilted forwards slightly.

 Release the angle adjusting knob.

9 OPERATION

9.1

Cutting and Edging (fig. G)

Remove stones, loose pieces of wood and other objects from the cutting area.

The blade continues to rotate for a few seconds after the trimmer is
switched off.

 Hold the device at the upper and middle grips
 Swing the device in semicircles in front of the body (without touching the ground)

The optimal working angle for cutting is 30°.

 Allow the motor cutting line to stop rotating before switching "on" again.
 Do not rapidly switch off and on.