Powerplus POWXG6490 LOG SPLITTER 1500W 520MM EN - Manual (Page 7)

POWXG6490 EN
Copyright © 2014 VARO NV P a g e | 7 www.varo.com
6 ASSEMBLY
6.1 Preparing the Log Splitter for Use
Carefully remove the log splitter from its packaging and place it on the accompanying
Styrofoam block so that the wheels and foot can be mounted.
Careful: Not placing the log splitter on the block can cause damage to the
motor’s ventilation cap or the motor casing itself.
Before using the log splitter, the foot at the front of the machine must be mounted and
fastened with the proper screws and bolts. Next, mount the wheels on their axel. Place the
wheel on the axel, and fasten it with a washer. Never use the log splitter if it is not in perfect
operating condition or if it needs service.
Familiarize yourself with the instruction manual and its operating and safety mechanisms, as
well as the log splitter’s functions before using the machine for the first time.
6.2 Bleed screw
On the back of the machine is a bleed screw (#14) that must be
loosened 3 to 4 rotations before the log splitter may be used for
the first time. When moving the log splitter, the screw must be
tightened again to avoid oil leakage
7 OPERATION
 Place the log splitter on a table that is 60-75 cm high.
 Connect the electric log splitter to 230 Volt power supply.
 When using an extension cord, keep it away from the wood-splitting wedge or places
where it could be damaged or torn.
 Place the log on the push plate. The push plate ensures that the log is positioned correctly
in relation to the wedge. If the log is not steady, try turning it over.
 Press the ON/OFF button (6) of the motor with your right hand and activate the operating
handle (3) with your left. Push the push plate forwards to split the log.
Caution: if the switch is not fully depressed the switch contacts may burn
in.
 If the log does not split at once do not keep the cylinder depressed. Draw the push plate
back and try again. A small piece of wood can be difficult to split when it is somewhat
knotty. Logs with a uniform structure are easy to split even when large. When the wood is
too hard do not use this machine as damage to the motor may occur.
 Repeat the process for short sawed pieces of wood.
 When you have finished you work, pull the plug from the socket, but do not yank on the
cord.