Powerplus POWXG4035 LEAF BLOWER/VACUUM 3000W EN - Manual (Page 5)

POWXG4035
EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
8 BEFORE USE
Steps prior to operation
Only operate the device after completely assembling it. Prior to each use, check the power
cord for signs of damage. Under no circumstances should the power cord be used if it shows
any signs of damage.
9 ASSEMBLY
You new blower vac requires very little assembly work before it is ready for use.
ATTENTION ! The 2 supplied tube parts have to be mounted otherwise the machine will NOT
work ! (build in safety switch !)
9.1 safety switch
Your blow-vac has a build in safety switch that prevents the machine from being started in
case the supplied tubes are not mounted.
9.2 Shoulder strap:
The shoulder strap will be supplied inside the leaf bag. Take the shoulder strap out of the leaf
bag, open the snap fastener, thread the strap through the metal clip on the top of the motor
casing and then close the snap fastener. To adjust the shoulder strap to the required length,
simply slide the adjustable strap buckle forward or backwards.
9.3 Leaf bag.
To secure the leaf bag to the machine, simply attach the buckle to the top tube section
and pull the expanding bag opening over the leaf discharge point on the bottom of the motor
casing. Then tighten the securing belt.