Powerplus POWXG6107T LAWNMOWER 1600W 420MM +GRASS TRIMMER EN - Manual (Page 5)

POWXG3009
EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
6 ADDITIONAL SAFETY RULES FOR GRASS TRIMMERS
 Grass trimmers must not be used by children or untrained persons.
 Wear stout shoes or boots to protect your feet.
 Wear long trousers to protect your legs.
Only connect the appliance to an electric circuit which is protected by an
earth leakage switch (30 mA).
 Check the appliance before use. If it is damaged, it must not be used.
 If the unit is damaged, have the damage repaired by an authorized repair agent.
 Do not use the appliance if the mains cable is damaged or worn.
 Before use check the extension cord for possible wear and tear. In case of damage,
immediately remove the mains cable from the wall socket. Do not touch the cable before
the mains cable has been removed from the wall socket.
 Do not use the appliance in the presence of children and/or animals.
 Only use the appliance in daylight or with good lighting.
 Never use the appliance without the guard in place.
 Before using the appliance, remove sticks, stones, wire and other obstacles from the
surface on which you intend to work.
 Only use the appliance in an upright position, with the knifes pointing to the ground. Never
switch on the appliance in another position.
 Always keep your hands and feet away from the knifes.
 Avoid touching the knifes.
 Make sure that the mains cable does not touch the knifes.
 Before putting the appliance down, switch it off and wait for the knifes to come to a
complete standstill. Never attempt to bring the knifes to a standstill yourself.
Beware. After switching off the appliance it continues to rotate for a short
time.
 Only use the type of knifes recommended by the manufacturer.
 Remove the plug from the wall socket when you have finished, before servicing, or when
the appliance is not being used.
 After use, always store the appliance safely and out of the reach of children.
7 ASSEMBLY
Warning! Before assembly, make sure that the tool is switched off and
unplugged.
7.1 Shaft assembly
WARNING: Ensure that the excess wire between the switch handle and motor housing is not
twisted and is enclosed in switch handle and motor housing during assembly of the unit.
Failure to do so may result in damage to the wires and/or the unit or serious injury to the
operator including electrocution.