Powerplus POWX410 POWER STATION 4-IN-4 EN - Manual (Page 6)

POWX410
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
BATTERY CONDITION LIGHTS
1
st
green light Indicates that the battery is still in order and can charge
1
st
green light + 2
nd
green
light
Sufficiently charged
1
st
green light + yellow
light
Weak / needs charging
2 groene lampjes + yellow
light Weak / needs charging
1
st
green light + red light Empty / needs charging
Do not drive with power station while charging.
8 OPERATING INSTRUCTIONS
8.1 Jump start
Under no circumstances allow the red and black clamps to touch each
other or a common conductor.
 Switch off the engine of the vehicle or
boat.
 Connect the “
+
“(red) cable to the positive
terminal of your car battery. Then connect
the “
-
“（black）cable to the engine,
vehicle frame, or remote ground.
 Do not connect the negative clamp to the
negative battery terminal!
 Connecting to the negative battery terminal is an unsafe practice and increases the
possibility of sparking near the batteries explosive gases.
 Now you can start your engine. As soon as your car is started disconnect the cables from
your car in the reverse order.
 If your battery is so dead that your ignition light does not come on let the Power Station
stay connected to your battery for 10-20 minutes prior to attempting to start your car.
8.2 Compressor operation
DO NOT OVER INFLATE!
 This air compressor is designed for light duty.
 Please allow the air compressor to cool if operating for more than 10 continuous minutes.
 This air compressor and any other electrical device should be kept away from all children.
OPERATING INSTRUCTIONS
 Remove the air hose located in the compartment on the back of the unit.
 Connect air hose to item to be inflated and use included adaptors if needed.
 Move the handle in the air hose down to lock adaptor in place.