Powerplus POWX357 PAINT SPRAY STATION 900W EN - Manual (Page 10)

POWX357
EN
Copyright © 2012 VARO P a g e | 10 www.varo.com
11 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
83 dB(A)
Acoustic power level LwA 96 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 0,1 m/s² K = 1,5 m/s²
12 TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
Motor hums but
does not spray or
irregular spraying. Worn swirl head
Pick up pipe not in the right
position
Blocked pick up pipe
Blocked nozzle
Blocked filter
Control knob needs adjustment Replace swirl head.
Re-adjust pick up pipe.
Clean with thinner.
Clean nozzle.
Clean with thinner.
Adjust.
Atomization is not
good. Volume adjustment is not correct.
Paint too thick Adjust.
Check viscosity of the paint.
Over painting. Spray gun not clean, or not
lubricated resulting in piston being
stuck in cylinder
Too much paint
Viscosity too low Disassemble spray gun and clean
with thinner.
Adjust the volume clockwise to
reduce spraying. Two thin coats
are better then one
Check viscosity
Motor louder than
normal. Spray gun not clean, or not
lubricated, resulting in piston being
stuck in cylinder Disassemble spray gun and clean
with thinner.
No spray, no
sound. No electricity Check power supply
Operating sound
not right. Poor output adjustment
Not enough paint in the container
resulting in air being sucked in.
Not diluting properly or not passing
pick up pipe completely. Re-adjust
Refill with paint.
Check pick up pipe and viscosity
level.
“Orange Skin”
excessive fogging. Incorrect solvent is used
Spray gun too far from the surface.
Paint too thick Use correct solvent.
Hold spray gun closer to the
object.
Thin the paint