Powerplus POWX350 PAINT SPRAY GUN 120W EN - Manual (Page 8)

POWX350 EN
Copyright © 2011 VARO P a g e | 8 www.varo.com
9 TECHNICAL SPECIFICATIONS
Voltage 230-240V
Frequency 50Hz
Power input 120W
Maximum nozzle flow rate 320 gr/min
Container capacity 800 ml
Nozzle diameter 0.8 mm
Max viscosity 50din/sec
10 SOUND EMISSION
Noise emission values measured according to relevant standard.
Acoustic pressure level LpA
88 dB(A) K = 3 dB(A)
Acoustic power level LwA 101 dB(A) K = 3 dB(A)
ATTENTION ! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration) 18,60 m/s² K = 1,5 m/s²
11 TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
Motor hums but
does not spray or
irregular spraying. Worn swirl head
Pick up pipe not in the right
position
Blocked pick up pipe
Blocked nozzle
Blocked filter
Control knob needs adjustment
Replace swirl head.
Re-adjust pick up pipe.
Clean with thinner.
Clean nozzle.
Clean with thinner.
Adjust.
Atomization is not
good. Volume adjustment is not
correct.
Paint too thick
Adjust.
Check viscosity of the paint.
Over painting. Spray gun not clean, or not
lubricated resulting in piston
being stuck in cylinder
Too much paint
Viscosity too low
Disassemble spray gun and
clean with thinner.
Adjust the volume clockwise to
reduce spraying. Two thin coats
are better then one
Check viscosity
Motor louder than
normal. Spray gun not clean, or not
lubricated, resulting in piston
being stuck in cylinder
Disassemble spray gun and
clean with thinner.
No spray, no
sound. No electricity Check power supply
Operating sound
not right. Poor output adjustment
Not enough paint in the
container resulting in air being
sucked in.
Not diluting properly or not
Re-adjust
Refill with paint.
Check pick up pipe and
viscosity level.