beautypg.com

Electronic overload protection, Temperature-dependent overload protection, Maintenance and cleaning – Powerplus POWX085 CONCRETE/PAINT MIXER 1600W EN User Manual

Page 7: Technical data, Sound emission, 9 maintenance and cleaning, 10 technical data, 11 sound emission

background image

POWX082 & 085

EN

Copyright © 2011 VARO NV

P a g e

| 7

www.varo.com

8.6

Electronic overload protection

An electronic overload device protects the motor against damage when the tool is under an
extreme load. In this case, the motor stops and only starts up again when the feed is reduced
or the load removed (only model POW X085)

8.7

Temperature-dependent overload protection

To prevent the motor from overheating under an extreme continuous load, the safety
electronics switches the motor off when it reaches a critical temperature.
After a cooling-down time of around 3 - 5 min., the machine is ready for operation at full load.
If the tool is warm from operation, the temperature-dependent overload protection will respond
earlier.

9 MAINTENANCE AND CLEANING

Attention !Before performing any work on the equipment, pull the power
plug.

 Liquids must not be allowed to get into the inside of the appliance. Use a soft doth to clean

the casing. Never use benzine, solvents or cleaning agents that are aggressive on plastics.

 Wherever possible, always clean the mixing tools immediately after finishing work.
 Clean the air vents on the motor housing from time to time.
 When the carbon brushes have run out ,the tool switches itself off.
 Check the carbon brushes after approx. 100 hours of operation; if necessary replaced them

and clean the motor housing.

 Refill the grease in the gearbox after around 200 hours of operation.

CAUTION! To maintain the protective insulation, a safety inspection must
subsequently be carried out on the machine. For this reason, such work
must only be performed by an electrical workshop.

10 TECHNICAL DATA

POWX082

POWX085

voltage / frequency

230 V / 50 Hz

230 V / 50 Hz

Power:

1200W

1600W

Idling speed

1st gear

150-300 min-1

150-300 min-1

2nd gear

300-650 min-1

300-650 min-1

Mixer diameter:

140 mm

160 mm

Weight:

5,7 kg

6,0 kg

Protection class:

II/

II /

11 SOUND EMISSION

Noise emission values measured according to relevant standard.

POWX082

POWX085

Sound pressure (LpA)

86 dB(A)

K = 3 dB(A)

91 dB{A)

K = 3 dB(A)

Sound power (LwA)

99 dB(A)

K = 3 dB(A)

104 dB(A)

K = 3 dB(A)