Powerplus POWX066 ANGLE GRINDER 2400W Ø230MM EN - Manual (Page 8)

POWX066 EN
Copyright © 2010 VARO p a g e | 8 www.varo.com
8 OPERATING MODES
8.1 Rough grinding:
For the best rough grinding results, hold the grinding wheel at an angle of between 30° and
40° to the workpiece surface and guide back and forth over the workpiece in steady
movements.
8.2 Cutting:
When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane.
The cutting wheel must have a clean cutting edge. A diamond cutting wheel is best used to cut
hard stone. It is prohibited to use the machine on asbestos materials!
Never use a cutting wheel for rough grinding.
9 FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS AND
CUTTING WHEELS
9.1 Flange arrangements when using a depressed centre or straight grinding wheel
1 Clamping flange
2 Flange nut
9.2 Flange arrangement when using a depressed-centre cutting wheel