Powerplus POWX0460 BELT SANDER 950W EN - Manual (Page 5)

POWX0460 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
7 OPERATION
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
7.1 Switching Onoff
 To switch the tool on, press the on/off switch.
 To switch the tool off, release the on/off switch.
7.2 Continuous operation / ON/OFF lock button
to switch on :
 Hold the on/off switch pressed
 Press the lock button
 release the on/off switch
to switch off :
press the on/off switch once to release the lockon button
7.3 Speed adjusting dial
Your POW X0460 is equipped with a variable speed selector .
You can turn the speed selector switch from 1 to 6 to set the desired belt speed.
7.4 Mounting a sanding belt
 Pull out the locking lever in the side of the belt sander to loosen the sanding belt
 Take a sanding belt of the required grain size and place it on the rollers. Make sure that
the arrow on the inside of the sanding belt points in the same direction as the arrow on the
machine.
 Make sure that the sanding belt is straight and centered on the rollers.
 Push the clamping lever back.
 Switch the machine on to let the sanding belt run. With the machine switched on, turn the
adjusting screw until the sanding belt keeps running straight.
The sanding belt must be fitted firmly on the sanding pad and should not
come loose.
7.5 Collecting the dust
dust box :
Push and slide the dust collection box into the connector for dust collection. Make sure the
grooves on the right and left of the connector are into place and it is secured before starting
the operation..
7.6 Auxiliary handle position adjustment
Pull out the lock on the right of the handle and rotate in desired position. Put the lock back in
place by pushing towards handle.