Powerplus POWX026 IMPACT DRILL 710W EN - Manual (Page 5)

POWX026 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
Always use ear-protection, when machine is in use!
Recommended nominal operating-time: approx. 20 minutes under
permanent load.
Rest after permanent operation: approx. 5-10 minutes.
7 OPERATION
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
7.1 Changing drill or screwdriver bit
 Insert the chuck key in one of the three holes on the side of the chuck (1), turn to open.
 Insert the desired drill or screwdriver bit in the chuck and turn the chuck key the opposite
way until the chuck has a firm grip on the drill or screwdriver bit.
 Check that the drill or screwdriver bit is in the centre of the chuck and is secure.
7.2 Switching on/off (Fig. 1)
 Plug the cord set into power socket.
 To start the tool by squeezing the ON/OFF switch (4).
 Release the ON/OFF switch to stop the tool.
 If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
 To release the ON/OFF switch (4) and turn the tool off.
7.3 Forward/reverse lever (Fig. 2)
 The forward/reverse lever (3) is to determine the rotation direction of the chuck.
 To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.
7.4 Variable speed (Fig. 3)
This tool has a speed control dial (5) that delivers higher speed by turning to the
“+” direction,
and delivers lower speed by turning to “-”direction.