Electrolux FJD 1266 W - Manual (Page 10)

10
Operating Sequence
Before the first wash, we recommend that you run a
cotton cycle at 60°C, without any laundry in the
machine, to remove any manufacturing residue from the
drum and tub.
Pour 1/2 a measure of detergent into the dispenser
drawer and start the machine.
1.Load the laundry
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2.Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment
.
If you wish to carry out the prewash or a soak
programme (OUTDOOR SPORTS), pour detergent into
the appropriate compartment marked
.
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked ,
without exceeding the «MAX» mark.
Close the drawer gently.
C0065 C0064
P0004
4. Switch the machine on
Press the ON/OFF button to switch the machine on. The
display will show three blinking dashes or a blinking
zero. The light above the button will light up.
5. Select the desired programme/
fabric
Press the FABRIC button repeatedly, in order to select
the desired programme/fabric. The relevant light will
light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The START/PAUSE button
light will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the cycle.
PREWASH
WASH
SPIN
RINSES
DRAIN
SYNTHETICS
DELICATES
COTTONS
HAND
WASH
WOOL
FABRIC
--- ---
0
ON / OFF
132994630 .qxd 6/6/02 2:59 PM Pagina 10 (Nero/Process Black pellicola)