Powerplus POWX0070LI DRILL/SCREWDRIVER 18V LI-ION ONE FITS ALL EN - Manual (Page 8)

POWX0070LI EN
Copyright © 2013 VARO P a g e | 8 www.varo.com
 When fully charged both lights will be constantly lit.
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
3. Frequently monitor the charger and battery pack while connected.
4. For a fully discharged battery or a new battery, allow the battery pack to charge for 1
hour. The red and green lights will stay on (not flash) when the battery is finished
charging.
5. Unplug the charger and disconnect it from the battery pack when finished.
6. Allow the battery pack to cool completely before using it.
7. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery
’s release button in and pull the battery pack off at
the same time.
8.2 Inserting and removing the battery (Fig 2)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position
 Remove the battery pressing the battery latches and at the same time pull the battery
pack off.
 To insert the battery, push the battery pack onto the contacts of the tool.
8.3 Installing and Removing a Bit and a Drill (Fig 3)
This drill has a keyless chuck to prevent the bit or drill from loosening.
 Hold ring A of the drill chuck tight with one hand.
 Turn upper ring B anticlockwise with the other hand until the drill chuck opening is large
enough to accept the tool.
 Insert the drill or the screwdriver bit into the drill chuck.
 Turn ring B clockwise until the tool is clamped tightly.
Remove the tool in the opposite way.
8.4 Switch (4)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
8.4.1 Switch lock (Fig 4)
The switch trigger can be locked in the center position.
This helps to reduce the possibility of accidental starting when not in use. To lock the switch
trigger, place the direction of rotation selector in the center position.