Powerplus POWX0073LI IMPACT SCREWDRIVER 18V LI-ION ONE FITS ALL EN - Manual (Page 6)

POWX0073LI EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
6 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND
CHARGERS
6.1 Batteries
 Never attempt to open for any reason.
 Do not store in locations where the temperature may exceed 40 °C.
 Charge only at ambient temperatures between 4 °C and 40 °C.
 Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given in the section “Protecting the
environment”.
 Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
 Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
 Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:

Carefully wipe the liquid off using a cloth. Avoid skin contact.

In case of skin or eye contact, follow the instructions below:
 Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.

In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
6.2 Chargers
 Use the charger provided with the tool only to charge the battery
 Never attempt to charge non-rechargeable batteries.
 Have defective cords replaced immediately.
 Do not expose to water.
 Do not open the charger.
 Do not probe the charger.
 The charger is intended for indoor use only.
7 ASSEMBLY
7.1 Selecting correct socket
Always use the correct size socket for bolts and nuts. An incorrect size socket will result in
inaccurate and inconsistent fastening torque and /or damage to the bolt or nut. Refer to
accessories section for socket size.
7.2 Installing or removing socket (Fig. 1)
 Always be sure that the tool is switched off and the battery pack is removed before
installing or removing the socket.
 To install the socket, push it onto the anvil of the tool until it locks into place. To remove
the socket, simply pull it off.