beautypg.com

Assembly and operation, Testing the sequential trip safety mechanism, Loading brad nails and staples. (fig 2&3) – Powerplus POW737 NAIL/STAPLE GUN EN User Manual

Page 5

background image

POW737

EN

Copyright © 2015 VARO

P a g e

| 5

www.varo.com

 Never block the safety device.
 Switch the machine off when you take a break and when the work is completed.
 Wear ear protectors.

7

ASSEMBLY AND OPERATION

Warning: This nailer/stapler is NOT suited for nailing or stapling into
concrete, masonry, bricks or metal.

Warning: Do not fire if brad nails or staples are jammed in the nose (4)
section.

Warning! This nailer has a sequential trip safety mechanism. With the nose
of the nailer contacting a surface, the unit will fire only once when the
trigger is pulled.

7.1

Testing the sequential trip safety mechanism

 The nailer should not fire if the safety (3) is not depressed against the workpiece.
 Make sure the switch is turned off.
 Empty the magazine (5) of nails.
 Check that the trigger (6) and safety (3) of the tool, move freely, without sticking.
 Plug the tool into the power outlet.
 Test the tool by depressing the safety (3) of the tool against the workpiece without pulling

the trigger (6). The tool must not cycle (fire). If it cycles (fires), stop immediately and take
the tool to an qualified service technician for repair.

 Hold the tool away or off of the workpiece. The safety (3) of the tool should return to its

original position. Squeeze the trigger (6). The tool should not cycle (fire). If it cycles (fires),
stop immediately and take the tool to an authorized service technician.

 Depress the safety (3) of the tool against the workpiece and squeeze the trigger (6). The

tool must cycle (fire) once only. If it fails to cycle (fire) or fires more than once, take it to an
authorized service technician.

Warning! Disconnect the nailer from the power outlet whenever loading it.

7.2

Loading brad nails and staples. (Fig 2&3)

 Depress the lever (10) and extend the inner magazine (11) all the way out.
 When loading brad nails, make sure you insert the pins of the nails on the side of the

magazine (5) with the groove in it. The brad nails should fit into the groove. When loading
staples, insert them crown up, onto the magazine (5).

 Slide the extended inner magazine (11) back until the lever (10) clicks into place. Do not

force the inner magazine (11) or you may damage the tool.

When the unit is loaded with fasteners and you are ready to begin, plug the
nailer/stapler power cord (8) into a power outlet.

 Hold the tool with both hands, so that the nose (4) is flat against the workpiece, making

sure that the safety (3) is also firmly against the workpiece.

 Gently squeeze the trigger (6) to fire the tool.

Note: practice depth adjustment on scrap material first.